Author Message 3dmus Posted: 7/23/2012 Quote message  HI - I just noticed that the design I created in Artisteer 3 has got an issue when importing into the 4 Beta, Main issue is that part of my header image (a PNG image with transparency) is meant to go outside of the main sheet width (overhanging if you will). With Artisteer 3 this is not an issue if you set the header to page width (with 100% transparency). In the 4 Beta my image gets cut off at the sheet end.   aric montgomery Posted: 7/23/2012 Quote message  same here   Garry Posted: 7/23/2012 Quote message  I'll suggest you to contact Artisteer support with your saved .artx file.